2 ea Body or Bumper Hole Patch Plug Left and Right 4-3/8" x 2-5/8" Triangle

Description

Can’t find a solution to fill a body or bumper hole in your former police cruiser?  Check this out!
Two (2 each) Triangular Shaped Made in U.S.A. pressure sensitive adhesive hole patches made from automotive grade urethane.  They are mirror images ideal for left and right side hole concealment.  Installation horizontally or vertically oriented as desired.
Available in Gloss Black or Gloss White.
Featuring a strong industrial 3M pressure sensitive
adhesive
backing for peel and stick installation (50 degrees minimum installation temp).
Specifically designed to cover any relatively flat hole where there is a minimum of 3/8 inch margin of overlap.  It is not designed for significant radius surfaces, gentle curves only.  It is ideal for light bar wiring harness holes or luggage rack holes in police vehicle roofs, antenna holes or holes in the firewall. Unlike the rubber or cheap plastic caplug hole plugs, this patch has a very stealthy low profile appearance.
Patch Dimensions:
Measurements: 4.375" High x 2.625" Wide (at widest point) x
.060” thick gently tapered at outer edge
Colors:
Paintable Gloss White, or Gloss Black
,
blends nicely into body panels with a low profile look without the unsightly dull black bump appearance like the rubber plugs.
These patches are compatible with all standard automotive finishes including basecoat / clearcoat.  Prep and paint as you would any automotive spot refinish repair.
Installation:
Clean all wax, spent adhesive residue, RTV silicone and any other foreign substances around the hole to be filled. For particularly stubborn spots, use a detergent solution then rinse with clean water and dry thoroughly.  Use the included alcohol wipe the area then carefully peel the backing off the patch and center over your hole pressing down around the outer edges only.  Avoid “touch” type car washes for 24 hours and surface must be at 50 degrees F minimum.  It may also be helpful to apply painters tape in an "X" across the patch for 12-24 hours then remove.
If you are looking for a more squared look patch,
check out our other listings
for our rectangular
4.250 inches High x 1.50 inches Wide
Bumper Patch offering.
Let us know if you have any questions.
Thanks for looking!
Nennoguy
Nenno Products LLC